406mm Bottom Fixed Full Extension Drawer Slides
406mm Bottom Fixed Full Extension Drawer Slides Details
32mm hole pattern for easy installation of drawer runners
Lever disconnect for easy drawer removal
Ball retainer latch and ramps for easier drawer insertion
Drawer adjustment without removal
Metal ball bearing retainer with 3 ball bearings per 25mm (1”) for smooth and quiet operation
Polymer stop cushions
These are a handed drawer runner you will receive a LH & RH runner and as such can only be fitted on the corresponding side.
406mm Bottom Fixed Full Extension Drawer Slides Description
Full extension drawer runners manufactured in steel with a zinc finish with a maximum weight capacity of 45k. To ensure the drawer runners are correctly fitted they require a building in width of 12.5mm either side. With 2 brackets at either end of the drawer runner for screwing up into the drawer side for additional support. Featuring a disconnect lever and steel ball bearing case this will ensure an easy fitting experience and also a smooth action maintenance free drawer runner. Fitted with a rubber back stop for a positive shut, these drawer runners extend the full length of the drawer runner enabling easier access to the drawer and contents. Ideally used in the bedroom, kitchen or office where a drawer requires a heavier weight capacity.
Manufactured in the USA by Knape & Vogt this is a high spec drawer runner manufactured to the highest standards.