Knape & Vogt 10" Over Extension Drawer Runner

Knape & Vogt 10" Over Extension Drawer Runner Measurements

Non-handed and 32mm hole pattern for easy installation of drawer runners

Lever disconnect for easy drawer removal
Ball retainer latch and ramps for easier drawer insertion
Drawer adjustment without removal
Metal ball bearing retainer with 3 ball bearings per 25mm (1”) for smooth and quiet operation
Polymer stop cushions

Sold in Pairs

25mm Over-travel

254mm (10”)

Weight 45Kg

Knape & Vogt 10" Over Extension Drawer Runner Description

Over extension drawer runners manufactured in steel with a zinc finish with a maximum weight capacity of 45kg. To ensure the drawer runners are correctly fitted they require a building in width of 12.5mm either side. Featuring a disconnect lever and steel ball bearing case this will ensure an easy fitting experience and also a smooth action maintenance free drawer runner. Fitted with a rubber back stop for a positive shut, these drawer runners over extend the length of the drawer runner by 1” enabling easier access to the drawer and contents. Ideally used in the bedroom, kitchen or office where a drawer requires a heavier weight capacity.  When fitted vertically as a pair they will hold 45kg if used horizontally the weight limit is reduced by three quarters.

Manufactured in the USA by Knape & Vogt this is a high spec drawer runner manufactured to the highest standards.